Right then, Poll 2 has closed. The poll was:
Question: “What is your preferred mech pencil lead diameter?”
The 268 votes were cast as follows:
0.3mm x 19 (7%)
0.5mm x 114 (42%)
0.7mm x 59 (22%)
0.9mm x 30 (11%)
1.1 to 1.4mm x 15 (5%)
2mm x 20 (7%)
Even bigger x 11 (4%)
Nothing too surprising here, with 0.5mm a clear winner, and 0.7mm an easy second. I was a little surprised at the size of “the tail” – 0.9mm and bigger getting a combined 28% of the vote. A few manufacturers push 0.7mm over 0.5mm leads due to strength issues, but you could interpret this poll to imply it’s not that big a deal. On the other hand, voters on this poll might not be representative of the pencil using population at large and so skew the results towards 0.5mm.
Now hopefully I’m not going to go overboard on polls, but I’ve got a couple more questions coming soon.
Tuesday, August 28, 2007
Subscribe to:
Post Comments (Atom)
Posts
+of+Lamy+2000+%2B+Stella+Artois.jpg)
8 comments:
Wilson - you had a comment here, but its been deleted - not sure if by you, or me by accident. I've got a copy if you want me to re-post it?
Interesting vote! Iguess most those non stationary fanatics use 0.5mm pencil.
Dave - I posted a comment but then I read it later and I didn't think it said anything useful. I might repost a better comment later.
Wilson - OK, but I didn't think it was that bad or useless.
I know I'm too late but my vote's for 0.5mm. I guess that makes me a non-stationary fanatic in griff's eyes!
I'm on the fence here. My official vote was for 0.7mm. It's what I use the most while out in the warehouse, however while at my desk I prefer 0.5mm.
i dont really know
Post a Comment